Uprated Anti roll bars.. Are they needed?

[0-60Motorsports]

Originally Posted by alexk

Reading this thread I have not upgraded up to now the anti roll bars.

However, I get a lot of roll at the track.
I was considering the H&R ARBs.

Any ideas ?

You would like the Ground Control front & rear adjustable set then....

http://www.ground-control-store.com/.../II=638/CA=265

[alexk]

I ordered the H&R as they have Swiss certification for road use.

I wish I could use the GC ones.
Wanted to get them when I had the Ohlins suspension.

[alexk]

Fitted this morning the H/R anti-roll bars. I will have to drive the car.
The front one is not hollow and it is much heavier than the OEM.

This Saturday I am going to Hockenheim so looking forward to see if the roll is reduced.
I will write a post later in my thread with all the geekie details.

[billyboysm3]

Originally Posted by alexk

Fitted this morning the H/R anti-roll bars. I will have to drive the car.
The front one is not hollow and it is much heavier than the OEM.

This Saturday I am going to Hockenheim so looking forward to see if the roll is reduced.
I will write a post later in my thread with all the geekie details.

Please do, are you running front on hard and rear on soft?

[shane@mbtech]

How low are you running Alex? And what suspension ?

[alexk]

Originally Posted by billyboysm3

Please do, are you running front on hard and rear on soft?

Front on middle (3 holes) and rear on hard (2 holes)

[alexk]

Originally Posted by shane@mbtech

How low are you running Alex? And what suspension ?

Front 33.5cm (hub center to arch) and rear 33cm (hub center to arch).
In other words 1.5cm lower than OEM front and rear.

Suspension is KW clubcsport