29-05-2018, 12:04 PM | #1 |
S2 - Picking it up
Join Date: May 2015
Posts: 59
Casino cash: $4159 |
Fitting flippers to bumper
Was just trying to fit mine to my new bumper and is there a knack to it so they sit bang on ??
|
29-05-2018, 02:20 PM | #2 |
S6, Sport On, Traction Off
Join Date: Dec 2010
Location: Norwich
Posts: 1,582
Casino cash: $17548 |
Sledge hammer and cold chisel, if that doesn't work - blow torch .
What seems to be the problem with the alignment, I didn't think you could fit them wrongly?
__________________
Mike R Sarcasm is just a free service I provide. Nordschleife, there's only two barriers to worry about - the ones on the left and the ones on the right . CSL number 044 |
29-05-2018, 04:40 PM | #3 |
S2 - Picking it up
Join Date: May 2015
Posts: 59
Casino cash: $4159 |
Lol that would work !
Seems tight to slip on at the inside ends then tuck the flap at the top under the bumper , almost seems like they need trimming at the top part. |
30-05-2018, 09:06 AM | #4 |
S6, Sport On, Traction Off
Join Date: Dec 2010
Location: Norwich
Posts: 1,582
Casino cash: $17548 |
They do need a bit of persuasion, but shouldn't need trimming
__________________
Mike R Sarcasm is just a free service I provide. Nordschleife, there's only two barriers to worry about - the ones on the left and the ones on the right . CSL number 044 |
30-05-2018, 10:27 AM | #5 |
S5 - Full Throttle
Join Date: Nov 2014
Posts: 318
Casino cash: $11097 |
They go in using a diagonal movement as I remember. Start at the inside end and move them upwards and inwards.
|
30-05-2018, 02:07 PM | #6 |
S2 - Picking it up
Join Date: May 2015
Posts: 59
Casino cash: $4159 |
Thank you gents.
|
04-06-2018, 12:53 PM | #7 |
S2 - Picking it up
Join Date: May 2015
Posts: 59
Casino cash: $4159 |
All sorted , just had to trim a little bit at the top.
|
|
|