Full Miltek system - initial impressions...

**glendog74** · 27-05-2008, 07:43 PM

I had a full Miltek system with race cats and ECU re-map fitted by Thorney Motorsport last Friday as well as an ITG filter element. I thought I'd share my initial impressions of the upgrade.

Pros:

1. Sounds pretty cool especially under hard acceleration - more dare i say like a 911 GT3! Also the trademark CSL induction note is still very apparent and hasn't been drowned out.

2. Power gain not immediately apparent from setting off but once you get into the mid-range it gets all angry and revs with even more urgency!

3. It looks nice and weighs less than OEM of course...

Cons:

1. It has a bassy drone between 2250-2750 rpm which can become wearsome when in town driving speeds or on slower motorway traffic speeds. This can be worked around by changing down a gear or by accelerating faster!

2. An annoying rattle emanates from the cat section on startup and remains quite distinctive until the car is fully warmed. A tad embarassing for such a 'nice/posh' car! Gonna ring TMS and check if this is the norm!

3. Fuel economy has gone down marginally (as expected) by 1-2 mpg on the car computer average calculator. The whole setup isn't exactly cheap of course at 3k...

Summary:

Overall I'm very pleased with it and TMS were really good also and looked after us for the day providing a lift and pick-up from Milton Keynes whilst system was fitted. It was good too to speak to John at TMS and have a look at his own (thorn covered & modded) CSL. There was also another CSL in for a Stage 3 tune.

BHP (at flywheel) prior to fit: 356
BHP (at flywheel) post fit: 379 (322 at wheels)

K1_MBR · 28-05-2008, 09:39 PM

I'm thinking of taking mine here www.primarydesigns.co.uk (as its only next door) when I have to stop shelling out for things like boilers, RTAB's and wheel bearings!

englebert · 03-06-2008, 10:21 PM

The only appeal the Miltek had for me was that i presumed being quiet it wouldn't be boomy. If this isn't the case, i'd rather just go for a balls out loud system...

Thorney · 04-06-2008, 06:42 PM

There's no such thing as a boom free E46 system I'm afraid, we're brutally honest aobut that. However the Milltek (which took me 7 goes to get right) is as near as zero boom as you'll get. It also gets better with a few miles. Certainly under 2400rpm there is a little but other than that its spot on.

**glendog74** · 05-06-2008, 11:24 PM

The boom doesn't really bother me too much but I'm a lot more aware of its presence when carrying passengers!

I've now done nearly 750 miles since fitting but the rattle is no better. I'm sure it is something very simple but will need to get it checked over. TMS have already told me they will replace any faulty parts if required, which is good to know...

Rags · 06-06-2008, 08:45 AM

Hi,

There are always pros and cons when fitting an aftermarket exhaust kit.

The power gains and the sound are excellent in the main.

I have a SS 100Cells and a Milltek system on my CSL and the only time I am conscious of the boom is when I have to take other people in the car - makes me wish I had the standard system on the car.

My real worry with the milltek is that it can appear to attract attention to the car when its going through town, people thinking you are a chav but at least the CSL isn't exactly a modified barry boys special

Also, through traffic its a tad annoying as well.

That said, the sound is brilliant and its the compromise you have when fitting a system like this.

Rgds

Kev.H · 29-06-2008, 03:56 PM

Quote:

Originally Posted by K1_MBR

I'm thinking of taking mine here www.primarydesigns.co.uk (as its only next door) when I have to stop shelling out for things like boilers, RTAB's and wheel bearings!

PD are awesome I have a tubular manifold on my focus rs by them they do headers exhaust for half the F1 grid

can even do inconnel

Rezmund · 12-07-2008, 10:16 PM

I didn't like the full Milltek and have that same rattling/vibration problem from the 100 cell cat nearly a year on which hasn't been sorted despite 3-4 trips to various parties under Millteks advisement. Not impressed for the c.£3k it costs.

27-05-2008, 07:43 PM	#1
glendog74 CSL Register Uber-poster! Tetris Champion! Join Date: Apr 2008 Location: Cornwall Posts: 8,861 Casino cash: $32299	Full Miltek system - initial impressions... I had a full Miltek system with race cats and ECU re-map fitted by Thorney Motorsport last Friday as well as an ITG filter element. I thought I'd share my initial impressions of the upgrade. Pros: 1. Sounds pretty cool especially under hard acceleration - more dare i say like a 911 GT3! Also the trademark CSL induction note is still very apparent and hasn't been drowned out. 2. Power gain not immediately apparent from setting off but once you get into the mid-range it gets all angry and revs with even more urgency! 3. It looks nice and weighs less than OEM of course... Cons: 1. It has a bassy drone between 2250-2750 rpm which can become wearsome when in town driving speeds or on slower motorway traffic speeds. This can be worked around by changing down a gear or by accelerating faster! 2. An annoying rattle emanates from the cat section on startup and remains quite distinctive until the car is fully warmed. A tad embarassing for such a 'nice/posh' car! Gonna ring TMS and check if this is the norm! 3. Fuel economy has gone down marginally (as expected) by 1-2 mpg on the car computer average calculator. The whole setup isn't exactly cheap of course at 3k... Summary: Overall I'm very pleased with it and TMS were really good also and looked after us for the day providing a lift and pick-up from Milton Keynes whilst system was fitted. It was good too to speak to John at TMS and have a look at his own (thorn covered & modded) CSL. There was also another CSL in for a Stage 3 tune. BHP (at flywheel) prior to fit: 356 BHP (at flywheel) post fit: 379 (322 at wheels)

04-06-2008, 06:42 PM	#4
Thorney S5 - Full Throttle Join Date: Sep 2007 Posts: 469 Casino cash: $3876	There's no such thing as a boom free E46 system I'm afraid, we're brutally honest aobut that. However the Milltek (which took me 7 goes to get right) is as near as zero boom as you'll get. It also gets better with a few miles. Certainly under 2400rpm there is a little but other than that its spot on. __________________ http://www.thorneymotorsport.co.uk

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
FULL CSL INTERIOR FOR SALE	karbonkid	Parts For Sale	50	27-08-2009 09:53 PM
Advice on a Tracker system	cslbecks	Main Message Centre	19	19-10-2008 09:26 AM
Near new Miltek 100 Cell Cat section	glendog74	Parts For Sale	3	22-08-2008 10:59 PM
Milltek Cat Back System, only covered 2000 miles	Rezmund	Parts For Sale	4	03-08-2008 11:00 AM
Loaded CSL does 7:22 full lap of Ring!	neil	Main Message Centre	1	06-11-2007 09:04 PM

28-05-2008, 09:39 PM	#2
K1_MBR S2 - Picking it up Join Date: Dec 2007 Location: Beaconsfield / Doncaster Posts: 60 Casino cash: $250	I'm thinking of taking mine here www.primarydesigns.co.uk (as its only next door) when I have to stop shelling out for things like boilers, RTAB's and wheel bearings!

03-06-2008, 10:21 PM	#3
englebert S5 - Full Throttle Join Date: Jun 2008 Location: Kent Posts: 397 Casino cash: $705	The only appeal the Miltek had for me was that i presumed being quiet it wouldn't be boomy. If this isn't the case, i'd rather just go for a balls out loud system...

05-06-2008, 11:24 PM	#5
glendog74 CSL Register Uber-poster! Tetris Champion! Join Date: Apr 2008 Location: Cornwall Posts: 8,861 Casino cash: $32299	The boom doesn't really bother me too much but I'm a lot more aware of its presence when carrying passengers! I've now done nearly 750 miles since fitting but the rattle is no better. I'm sure it is something very simple but will need to get it checked over. TMS have already told me they will replace any faulty parts if required, which is good to know...

06-06-2008, 08:45 AM	#6
Rags S4 - Getting the hang of it Join Date: May 2008 Posts: 223 Casino cash: $624	Hi, There are always pros and cons when fitting an aftermarket exhaust kit. The power gains and the sound are excellent in the main. I have a SS 100Cells and a Milltek system on my CSL and the only time I am conscious of the boom is when I have to take other people in the car - makes me wish I had the standard system on the car. My real worry with the milltek is that it can appear to attract attention to the car when its going through town, people thinking you are a chav but at least the CSL isn't exactly a modified barry boys special Also, through traffic its a tad annoying as well. That said, the sound is brilliant and its the compromise you have when fitting a system like this. Rgds

12-07-2008, 10:16 PM	#8
Rezmund S2 - Picking it up Join Date: Sep 2007 Posts: 55 Casino cash: $283	I didn't like the full Milltek and have that same rattling/vibration problem from the 100 cell cat nearly a year on which hasn't been sorted despite 3-4 trips to various parties under Millteks advisement. Not impressed for the c.£3k it costs.