CSLReg Display Plates

[phat///M3]

Originally Posted by Dan

No not kidding mate lol Spoke to Alex on it and it's fine, I can take a pic later and post it up if you want to see?

Are they all like that then?

[Dan]

Originally Posted by phat///M3

Are they all like that then?

I can't speak for others obviously so what do others say on the matter?

[phat///M3]

Originally Posted by Dan

I can't speak for others obviously so what do others say on the matter?

Pic solutions

[phat///M3]

Originally Posted by phat///M3

Pic solutions

Never thought I would use the whole solutions thing

[Dan]

Originally Posted by phat///M3

Never thought I would use the whole solutions thing

In don't!

[DuncanR]

I just removed my number plate holder, redrilled and moved it all along about 40mm !! sorted !

[phat///M3]

Originally Posted by DuncanR

I just removed my number plate holder, redrilled and moved it all along about 40mm !! sorted !

Poor bumper knew it would be better off with me

[phat///M3]

Recieved mine today, thanks a million Alex

Originally Posted by Dan

I can't speak for others obviously so what do others say on the matter?

Mine are the same, has to be down to the printers as the flag is different (not faded) and on the file used to make it, the letters are centered.

[karbonkid]

Originally Posted by phat///M3

Mine are the same, has to be down to the printers as the flag is different (not faded) and on the file used to make it, the letters are centered.

I have just had a chat with the printers and they told me all their settings for it to be centered when going to print were correct and are not sure why they would appear slightly off centre. TBH I didn't notice as its marginal, otherwise I would have queried it at the time.

For what they are initially going to be used for on track I think you will even find it hard to read the plate from a distance, let alone get a chance to get the tape measure out on it. Well.... not strictly true when knowing how slow some of you drive.

Joking aside, if this is an issue PM me and I will get another set made up for you.

I have been informed from the printers that all plates that are ordered from today onwards will be revised, but will have to be manually adjusted as the plate is centered on their systems.

[7.77]