1M Carbon parts

[Mark CSL]

Well the 1M was needing a little Carbon just so i could feel at home


Radio and Aircon panel

Got new trims from bmw as they are cheap and that way i can put the car back to standard if or when i sell it.

Sanded the trims then the resin went on

[Mark CSL]

After the resin goes tacky around 4 hours the carbon is put on and then the parts are put in a vacuum bag for another 6 hours.
Then they are taken out the vacuum bag.

[Mark CSL]

More coats for resin then trim the excess carbon sand the parts down and more resin.

[Mark CSL]

Another coat of resin then sand down again with 800grit wet and dry.
(No finger prints left)

[Mark CSL]

Then its time for the 2k clear.

[Mark CSL]

Snading agin this time 1500 grit then 2000 grit and polish and install
Just the ashtray gear surround and the cic trim