CSL Register - View Single Post

**Mark CSL** · 26-06-2013, 10:36 PM

This is how to change the window switch trim I am fitting a carbon one

Tools needed are a Phillips Screw Driver

Pull up on the gear knob

It will come off in your hand

Then pull up on this part when off release the green connector

Then remove the 2 screws You can see the Green connector on the right

Unclip the window switches on each side there are 2 clips on each side

Fit the switches in the new panel then place it down from the astray to the front then fit the 2 screws

Fit the rest of the trims not forgetting to connect the green connector
This is the finished part

I sell the carbon ones PM me for details

26-06-2013, 10:36 PM	#1
Mark CSL CSL Register Uber-poster! Join Date: Sep 2007 Location: Scotland Posts: 8,777 Casino cash: $42229	Window Switch Trim Removal This is how to change the window switch trim I am fitting a carbon one Tools needed are a Phillips Screw Driver Pull up on the gear knob It will come off in your hand Then pull up on this part when off release the green connector Then remove the 2 screws You can see the Green connector on the right Unclip the window switches on each side there are 2 clips on each side Fit the switches in the new panel then place it down from the astray to the front then fit the 2 screws Fit the rest of the trims not forgetting to connect the green connector This is the finished part I sell the carbon ones PM me for details __________________ www.procarkits.co.uk Last edited by Mark CSL; 26-06-2013 at 10:38 PM.