Quote:
Originally Posted by rs32
Firstly remove the screw cover inside the door pull – use a very thin-tip flat screwdriver and take care not to ruin the fairly soft plastic. Mine already had some scratches. Undo this screw fully with a Torx T20 bit and put in a safe place.
|
Actually you don't have to use a thin-tip flat screwdriver to remove that plastic blank plate - just push it on one corner and it will lift up the other corner allowing removal (hard to explain - but if you look carefully you'll see that there's a cutout built into it, allowing the blanking plate to 'pivot' and raise the other side so it'll pop out without prying.
Just a tip I found when I removed my door card for fun ...