Certainly more than a little annoying but we've made some good progress towards a settlement today. Hopefully we'll have it resolved before the end of the weekend and we can get cracking on a replacement engine.
For today's update we're finishing up the back axle, which means fitting our diff cooler and pump. Out came the custom loom for a (very) quick and dirty lay out in the car to check where best to mount the diff pump.
We also figured out where the rear firewall will be located. Next step is making up a template, then fabricating a firewall in carbon fibre.
In the meantime it's on with fitting the diff cooler and pump.
You may also notice a rogue driveshaft laying on the floor there. Turns out one of its universal joints is a bit graunchy so we'll fit another one next week.