Can someone do me a quick favour
 

:-D

Now I know its bloody cold - but could someone nip out and measure the centre of their wheel to arch. Need both front and rear on a standard setup car.

Trying to get my coils set perfect for geometry tomorrow.

:beer:

34.5mm front and rear, just on a normal tape measure
thats centre and going straight up to arch

:notworthy:

Spot on mate, thank you very much.

Currently my nose is 10mm higher, so i need to bring her down a notch or two to even it up.

Was confused because the front arch is a bit bigger - so pressumed hub-to-arch would be bigger also.

Hello,

The proper way to measure the ride height is from the base of the wheel rim through the centre line to the arch.

HTH

Jags