Bit of DIY on a spare steering wheel - updated with installed pics
 

So I had a spare steering wheel trim that was a bit beat up, so thought I'd give it a bit of DIY treatment ... Genuine Alcantara!!

Probably not to everyone's liking ... but meh .. :hahaha::birdman: I think it looks good :supz:

http://i115.photobucket.com/albums/n...ofP1010782.jpg
http://i115.photobucket.com/albums/n...ofP1010783.jpg
http://i115.photobucket.com/albums/n...ofP1010784.jpg
http://i115.photobucket.com/albums/n...ofP1010785.jpg
http://i115.photobucket.com/albums/n...ofP1010786.jpg

:thumbs::thumbs:Me likey

Thumbs up from me aswell :thumbs:

Have you got a photo of it with the centre/horn piece fitted???

I'm liking that. :thumbs: Nice.

I think it looks good. Don't like original finish there though.

Installed :thumbs: (I know the alcantara colour looks a little different between the steering wheel and the trim, but that's because the steering wheel is a different one to the one pictured above - this is my used 'driving' steering wheel, so it's a bit worn and beaten up)

http://i115.photobucket.com/albums/n...ofP1010817.jpg
http://i115.photobucket.com/albums/n...ofP1010821.jpg

Liking that:thumbs:

I like that. However, those rubber mats have got to go!

I love it...but then I'm an alcantara/suede tart...cover everything in it I say..

In fact I would have underware made out ot it..Did I say that out loud..:whistle:

Looks good, whats going on with the different seat base cushion?